
16
COMPONENT NAMES
KR-8900
When "KRT PRINT TYPE" is set to "NORMAL"
<R/K> mode
When measurement is done under the IOL mode, a reliability factor is printed out
following the Ι mark.
The reliability factor is formed with integers 1 to 9 in increasing order of reliability.
Additionally, if the reliability is high enough, the reliability factor is not shown in the
printout.
0#/'
4'(#
ޛ4ޜ
5
%;.
%#
8&
2&
#&& 02&
AA#/
0Q
-4
5'
5'
ޛ.ޜ
5
%#
-46#
ޛ4ޜ
%140'#&+#
%140'#&+#
&
*
8
%;.
#8'
// #
& & #
عع
عع
عع
& & #
عع
عع
عع
عع
612%10
ޛ.ޜ
&
*
8
%;.
#8'
// #
Bar code
Work ID No.
Patient No.
Instrument No.
VD (vertical distance)
Cylindrical power mark
Right eye measurements
Measurement Results of 3 right eye measurements
(recordable up to 10 measurements)
Typical value of riht eye
Equivalent spherical power of right eye
The ( ) mark is added when measurement values are not
fully reliable.
PD value
ADD (ordinary additional power)
Near vision PD value
Measured value of horizontal corneal curvature
Measured value of vertical corneal curvature
Average value
Corneal astigmatic power
Cornea diameter
ALL mode (example)
Low reliability mark
D1:Refractory power of second principal meridian
D2:Refractory power of first principal meridian
A1:angle of second principal meridian
Comentários a estes Manuais